Is there a way to adjust the door so it shuts more tightly.
Ford ranger door handle loose.
How to replace the ford ranger door handle.
Take your drill and 1 4 in bit to drill out the rivets.
I drive a 2001 ford ranger 4x4 my little brother so kindly used a normal key to try and open my truck.
You will likely need another.
I think it is the same for 2000 2011.
However i can start the engine and unlock the passenger side.
I ve tried detaching the battery and unlocking the doors form the inside a thousand times with both the truck running.
2006 ford ranger drivers door rattles.
Do i just take off the inside door panel and tighten it from the.
If the door on your ford vehicle is having problems opening and closing it could be because the hinges aren t positioned properly.
I have to pull up on the handle and then like rip it towards.
Unclip the door latch rod from the door handle.
The drivers door on my truck rattles as if it s not all the way closed.
Original poster 1 point 6 years ago.
Ford ranger forum forums for ford ranger enthusiasts.
Remove the debris with your flat blade screwdriver.
Engine tech forum 6 cylinder tech 4 0 sohc 4 0 ohv tech.
The door handle for the door is held in by two rivets use a punch and punch out the center of both rivets then use a 1 4 inch drill bit and drill out the rivets remove the handle and you will see that both upper and lower door latch cables are secured to it now you can pull on the cables with a pliers and open the door more then likely the handle is bad and pulling on the lower door.
I ordered one on amazon for under 10 need a metal drill bit and replacemen.
Ranger b series door handle is loose on 2000 ranger when i bought my 2000 ranger last year the door handle on the drivers side has always been very loose.
This is not an easy task.
While this might mean the hinges need to be replaced completely you might be able to fix the problem by adjusting the hinges.
Take your old broken outside door panel out.
Door gets stuck and hard to open.
Now i can t lock or unlock the driver side door with my key.
On the outside of the door lift the handle to expose to rivets.
It opens the door fine but now i would like to tighten it like the passenger side door.